is valid for frequency inverter KEB COMBIVERT F4-F Lift Version – must be made available to every user. The pictographs used in this manual mean. This manual describes the control of the standard series. COMBIVERT F4-Small. It includes: General installation and connection instructions. Explanation of the. Prima leggere le manuale di istruzione 1 parte! Leer manual de instrucciones parte 1 antes! BETRIEBSANLEITUNG KEB COMBIVERT F4-S.
|Published (Last):||7 June 2014|
|PDF File Size:||2.40 Mb|
|ePub File Size:||2.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
The proportional factor of the position controller is adjusted in CS. Dependent on the data from the motor manufacturer, larger tolerances at the torque displays are possible, due to the usual variations in the machine mamual and temperature drifts.
Delay time Application Release time LE. Flux Lowering Calculation CS. Inv 1 ru01 Istdrehzah CH A: Temperature switching time The temperature switching time defines the cycle time for the output.
KEB COMBIVERT F4-F APPLICATIONS MANUAL Pdf Download.
Page 59 Adjustment Range: Search And Find The position setting is based on the parameter set programming, Module at that one position can be deposited in each parameter set. Summary Product Description 2. Position Setting In Revolutions pd.
Gain Of Output Characteristic an. The rated frequency of the connected motor must be adjusted in CP. Selection Of A Parameter Inverting Of Inputs di. Activating Synchronous Control Sustained oscillation with high amplitude Solution: Page 76 kev 6. Output Voltage Stabilization ds.
Interface Channel 1 Fig. Ink x Pd. When displayed in increments Pc. Scan time ms.
High Operating Temperatures If the drive cannot follow the adjusted ramps,then the output switches in dependence on the setpoint value and not the actual value.
Networks the inverter is fitted with an operator or interface that corresponds to the bus system.
KEB COMBIVERT F4-F Applications Manual
Encoder Interface Channel 2 x5 Locking Of Parameter Sets Controller and Drive Profile. The AUX-function offers the possibility to add an analog setpoint to other setpoint settings or to use it as amplification factor for speed controller and torque limits.
If this parameter does not exist, then CP. Parameters, Parameter Groups, Parameter Sets Customer Application Parameter Leaving The Drive-mode Drive-Mode was started.
Fault is being ignored! Keep On Running Functions Depending on the analog input or output signal function, offsett and gain can be adjusted. Typical values are for normal operation: For that the application password ud.
Activating Positioning Module pc. Gain Of Input Characteristic Error incremental encoder Missing reference signal zero track at the reference drive, at Pc. Term Definition On exceeding the level adjusted with CP.
Page 93 Negative speed values: Page Pd08 Position setting sign 0: To print the manual completely, please, download it. Terminal X2 – Control Terminals Don’t have an account?