CARDAX 6000 PDF

Cardax FT Controller – Download as PDF File .pdf), Text File .txt) or read online. Installation Guide. Cardax FT Controller CAUTION This equipment contains components that can be damaged by electrostatic discharge. Ensure both you. The Gallagher Controller supports the following door readers: > Cardax IV Prox (Mifare, kHz, TIRIS). > Cardax IV Prox Plus (Mifare, kHz,. TIRIS).

Author: Tojanos Doutaxe
Country: Montserrat
Language: English (Spanish)
Genre: Photos
Published (Last): 14 April 2012
Pages: 423
PDF File Size: 1.76 Mb
ePub File Size: 14.11 Mb
ISBN: 214-7-68325-822-6
Downloads: 93564
Price: Free* [*Free Regsitration Required]
Uploader: Mauhn

This indicates the Cardax FT Controller is waiting for database information to be downloaded from the Server. Integrated Access Control and Intruder Alarms capability 2.

Cardax Ft Controller pdf

Controller The Gallagher Controller is specifically designed to support access controlled doors and integrated intruder alarms. High Spec variant only The High Spec variant of the Controller has a secondary Ethernet connection link to which communications can automatically be switched upon failure of the primary Ethernet connection.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Each device attached to a Cardax FT Controller must be allocated an “address”. The termination jumper on either GBUS circuit needs to be fitted if the Controller is the end device for this circuit.

TOP Related  IMANOL ORDORIKA PDF

Standard and Acrdax Specis a processing board for an intruder alarm and access control system. This picture is not to scale, therefore use the measurements provided.

Controller will reject WWW connections. Changes or modifications not expressly approved by Gallagher Security Management Systems could void the user’s authority to operate this equipment.

Gallagher Controllers | AES Group Ltd.

Cardas flexible configuration options to meet specific site requirements, Gallagher Controllers:. In the event of a catastrophic failure, after approximately 60 seconds the In-Service relay cradax. The cables should stow neatly and be held in place by the cable clamps fitted into the base of the Cabinet. The following initialisation procedures are detailed in the later section titled “Initialisation”: Following full antistatic precautions, disconnect all cables from the Cardax FT Controller Refer to the previous section “Component layout” for the location of the plugs.

Cardax Ft Controller pdf Download Report.

An upgrade of the Controller software via a USB memory stick is complete and the USB drive must be removed for installation to complete. Normal Startup – Configuration will be retained. Refer to the “Component layout” within this Installation Note for wiring this plug. On startup, the main application is run. The security of the installation ultimately depends on the way the Cardax FT Cabinet is installed.

TOP Related  ELEMENTOS DE ELECTROMAGNETISMO SADIKU PDF

The Cabinet door must remain closed for at least one minute for the initialisation of the optical tamper detectors to be completed. Install the component identification decal inside the Cardax FT Cabinet door. Set switch 2 to OFF open. Click the OK button. Cardax FT Controller Documents.

Cardax Ft Controller 6000pdf

Unused For factory testing only. On startup configuration and the IP address is deleted. This decal enables you to enter wiring and connection details and identifies the location and designation of cable connections, LEDs, etc. Communication between Cardax FT Controllers and lower level hardware items uses two Cardax-proprietary data communication formats. Page 2 1 November Introduction The Settings in bold specify the default new installation startup configuration.

The red Run LED flashes in the following sequence: Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Unused Unused Boot normally. No private key or certificate loaded. Close and lock the Cardax FT Controller cabinet door within ten seconds, i. One GBUS port to support: