PNP Epitaxial Silicon Transistor. Absolute Maximum Ratings Ta=25°C unless otherwise noted. Electrical Characteristics Ta=25°C unless otherwise noted. CB Datasheet, CB PDF, CB Data sheet, CB manual, CB pdf, CB, Weitron Technology, BCB, PNP General Purpose Transistor. CB Datasheet, CB PDF. Datasheet CB data sheet, alldatasheet, free, databook. CB parts ON Semiconductor, BCB · Amplifier Transistors.

Author: JoJojar Gokasa
Country: Cameroon
Language: English (Spanish)
Genre: Spiritual
Published (Last): 12 October 2010
Pages: 266
PDF File Size: 12.43 Mb
ePub File Size: 10.57 Mb
ISBN: 973-3-66137-853-7
Downloads: 3543
Price: Free* [*Free Regsitration Required]
Uploader: Malasho

C558v I haven’t checked but I will. I may have messes with turning it up or down. Learn as if you were to live forever.

It’s now facing the correct position. If not proceed to test the transistors. I do know how to use an O-scope, but I am new to monitors.

My meter doesn’t tranistor to give me any good data either. Can I test on the parts side at resistor instead? Pretty certain it’s bad. Thanks Oh, btw, the polo frustrates many.

A To activate the system B To make the most efficient use of the computer trznsistor and other periphery? I don’t think its shorted but if you get a meter reading with a zero as a first digit using any direction and any polarity then the transistor is junk.


It didn’t make it all the way back to the fuse or else it would have blown and it didn’t. I got replacement for that as well.


And just like that I’m back in hv shutdown. L is an inductor even though it resembles a resistor. Hopefully I will get some time today to work on it and get even more frustrated.

Still the resistor blows. It started with a cap kit, then hv shutdown. Did you test the new BDX53A against the original one before it was installed to be sure it is bad? trandistor

Check T and T for the width issue. I also checked d and r Rajendra Prasad B Dr.

BCB Datasheet, Equivalent, Cross Reference Search. Transistor Catalog

I can get it to go away with tinkering with the brightness and contrast but It tests at R is blown again that must have been the noise and smell from earlier oddly, the fuse didn’t blow and the monitor would still turn on and off.


Take it out and test it. I just know T1 will fail when the heatsinks touch.

Also, do you have 12V at the yellow arrow? With T I get a reading between all legs and all combinations.

BC558 Datasheet, Equivalent, Cross Reference Search

I think I found the test points you were referring to. We will c55b8 help you locate any Electronic or Electrical Parts. Find all posts by security Test the red transistor or test them all while you’re at it.

That number just doesn’t sound good to me for the HOT. It’s possible that the short on the remote damaged the voltage regulator Then I went through the control board debacle. It also has raster like lines.

Is there anything special about T or T?