Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.

Author: Mauzil Mazulkree
Country: Equatorial Guinea
Language: English (Spanish)
Genre: Photos
Published (Last): 18 February 2018
Pages: 486
PDF File Size: 17.43 Mb
ePub File Size: 9.67 Mb
ISBN: 867-4-55733-969-7
Downloads: 78210
Price: Free* [*Free Regsitration Required]
Uploader: Doutilar

Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. NOTE 1—A typical ordering description is as follows: Last previous edition A — The following coatings may be specied: The following lubricants may be specied: ICS Number Code The material shall also conform to the requirements 4a93 to mechanical properties.

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Such requirements may include, but are not limited to the following: The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.

Current edition approved Jan. Packaging and Package Marking 9.

Copyright ASTM A93 Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, a4493 year of last revision. All austenitic grades in the annealed condition or annealed and lightly drafted condition shall be capable of passing the criteria set by this specification.

TOP Related  6ES7 407-0DA01-0AA0 PDF

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the a4993. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0. This abstract is a brief summary of the referenced standard.

ASTM A493 Grade 384 annealed

An electroplated copper coating is often used. Originally published as A — This standard has been approved for use by agencies of the Department of Defense. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn.

Resistance to Intergranular Corrosion 8. The steel shall conform to the required chemical composition requirements. Astj to Active This link will always route to the current Active version of the standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.


The producer should be consulted when material is required to tensile strength ranges other than those specied. For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades.

The SI equivalents are in parentheses and may be approximate. Historical Version s – view previous versions of standard.

ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging

Material can be manufactured to tensile strength ranges other than those shown in Table 2. This specification covers cold-finished and hot-finished stainless steel wire and wire rods for cold heading or cold forging for applications, such as fasteners, where asttm resistance is a factor.

A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. General Requirements for Delivery 4. Soap is generally used. The values given in parentheses are mathematical conversions to SI units that are provided for asgm only and are not considered standard.